Solmer LTD Metal Ball Bearing Drawer runner Pr 310mm draw depth for 17mm (5 Pairs)

repairs to chest of drawers perfect product good price

I have been trying to find some of these for a long time and finally I can mend my drawers however the screws to fit the drawers to the runners are not long enough which was very disappointing

bit flimsy and needed degreasing before use but ok when fitted.

Multiple holes for various alignment and easy to install. Fits well although had them before from other source and don't last long if open the drawers not with care. Good value for money

Fitted a treat. Replacing old broken sliders. Crude but effective

Great product did the job

Excellent

Extremely cheap for the quality (50p per single slider). If you for some reason (like me) are not using them in drawers then they do slide both ways by 20cm. However ensure you keep them clean and if you cut them put stoppers so you don't lose any ball bearings (like I did). They aren't the easiest to slide but should be smooth and good enough for kitchen drawers. Just use some WD40 then spray grease to get them moving nicely. They are also surprisingly strong. Personally i was using them to make a 3d printer on a budget - though i recommend spending maybe £5 more to get smoother, easier movement. Though I doubt you'll be using them for that... I would note that if you trim the rails there is the danger that the ball ebaring carriage may get moved along when it shouldn't, which will cause differences in the amount of extension allowed.