Nilight - 90021B Light Bar Mounting Bracket Front License Plate Frame Bracket Holder for Off-Road Lights LED Work Lamps , 2 Years Warranty

Much heavier duty than I was expecting. Works great. Holes mount perfect for license plate holes, but the precut holes for mounting light bar are ok at best. If you want to run dual round eye pods this is great but if you want to run a true light bar then you’ll probably need a drill bit to make your own holes. Fits my 12” auxbeam bar perfectly but had to drill my own holes (I didn’t have the bar mounted up yet in the picture but you can see how it looks on the truck)

This is a good product. It's a light weight aluminum piece that mounted to the bumper via the license plate bracket. It only took a few minutes to mount and not drilling was required. I was happy it was a small, neat installation and it makes a good place to mount the fog lights I wanted to add.

Alumbra muy bien pero al instalarlo fue algo frágil, tuve que instalarle soportes extras para mi Camioneta

Fast shipping. As Described. Works as should.Pay the extra couple of bucks and get the one that comes with the LED. Doesn't hurt to have a spare, just in case.

Works great even holds my driving lights

Seems good quality, silver painted aluminum plate and bar so it is very lightweight, was a bit of a challenge to install on my 19 Chevy Colorado mainly because the license plate bracket is angled but solved that with some stacked washers, holds my light bar nicely

Everything about this is absolutely a time saver. I have a '02 sierra which has a very slight peak in the center of the bumper so it didn't sit flush. I just drilled out two other hole and used a couple washers to make it flush. My only issue was that with me having the 20in lightbar it made contact with the bar on top of the mount. My easy solution is to use the oval holes to mount your light in that allow you to slide the light front to back. Find something about 3/16-1/4in thick to space the light up a touch higher off the plate mounting surface. When you first install it slide it all the way forward towards the fat bar. That way when you go to tilt the light to angle it how you want it the light ends won't touch the fat bar where it curves back to the sides. It will also make it easier to get a 14mm wrench between the bumper and back of the lightbar to loosen and tighten the adjustment bolts. Then once you've got your adjustment where you want it you just have to slide it back if you want or leave it to the front like I did.

This item does NOT fit ANY usa license plate frames. When i got it i had to wait to get ahold of it due to it being shipped to my brother's house instead of mine. By then it was past 30 days. Come to find out it dont fit no license plates and instead, i slapped it on my lawn tractor and it's holes fit perfectly up to the tractor frame. Now it is being used to hold a aftermarket light for my tractor when i need to see a bit better.Dont buy if you plan to put this on a car/truck. Very small, fits only on tractors. I have a 2005 john deer mower and it fit on there just fine.