3" Front and 2" Rear Leveling Lift Kits for Ram 1500 4X4 4WD Coil Spring, dynofit Raise 3 Inch Front Strut Spacers and 2 Inch Rear Lift Spacer for Do-dge Ram Suspension Lift Kits 2009-2024

Installedand looks great. Left back just a touch higher than front as planned

Truck looks great. Can fit 35x12.5x20 tires with limited rubbing

Put these on my 09 ram 1500 and was able to fit a set of 35’s on them. Still a little bit of rubbing afterwards, a little trimming and grinding is necessary around the wheel well. If you’re using these with size 33’s or smaller, then you shouldn’t worry. For 37’s, a larger lift kit will be needed. Kept stock control arms and everything with this kit. Mechanic charged $350 for installation.

Put on a 2017 Dodge Ram 1500 4x4 Laramie. These strut spacers were at a good price point. I did purchase the Rough Country upper control arms and it made life so much simpler and is a MUST HAVE when putting any lift above 1.5”-2” on the front. Go ahead and spend the money and get quality parts to go along side these spacers. The only thing I can say was with 2 people with pretty decent knowledge of mechanicing, it took us about 6 hard hours of work to get these on but could have been less if I had known to loosen the alignment bolts from the frame to drop the axle down (only on a 4x4 I’m guessing). The back spacers went on very easily, but the front was a bit of a chore. The instructions were very cut and dry. YouTube was much better but even then we ran into problems. I bought a $30 spring compressor on Amazon which in my eyes after putting it in was a MUST HAVE. This is not a job for the weary or those with very limited tool selection. Almost every bolt we took off and put on was a different size wrench or socket. Also make sure you have heavy duty jack stands and a good floor jack and wheel blocks. I will say in a 4x4 we HAD to loosen the alignment bolts on the frame to get the axle to drop to the right depth to get it back in and had to use a 16 tooth socket and extension to get the stock bolts to tighten into the front spacers. We used bailing wire to keep the interior arm (inside the spring) compressed to get it back in easier. Over all I’m very happy with the results and I would recommend this under the right circumstances for install or pay the 400$ to get someone else to do it if you aren’t capable.

Everything fit well. Gave my truck a more aggressive look. Seems like quality material.

These are on my truck now would definitely recommend I’ve had no problems with them convenient easy to install

My 2020 ram 1500 responded fantastic to this leveling kit. Did not change the ride quality at all. Allowed me to fit 35” tires. Had to make some adjustments to the front fender liner to eliminate all rubbing.

Not compatible with my truck, course now I paid a mechanic to take my rear end apart for nothing. $300 later. The amazon seller should reimburse me for the mechanic charge for selling junk that dont match the vehicle and wasting customers money and time on labor. This seller should be disabled for doing such atrocities